24 Volt 500 Watt Speed Controller Installation and Wiring |
|
TNC Scooters Model Number | CTL-101170 |
Rated Voltage | 24 Volts |
Under Voltage Protection | 20.5 Volts |
Maximum Current | 30 Amps |
Rated For Chargers | ≤ 3 Amps |
Rated For Motors | ≤ 500 Watts |
Conversion Efficiency | 95% |
Dimensions | 3-1/4" L x 2-9/16" W x 1-1/2" H |
Under Voltage Protection: When
battery voltage falls to a specified value, the controller cuts off
battery output preventing over discharge and extending battery life.
(The cutoff value is approximately 20.5 volts, but varies drastically
from controller to controller.) Power Cut Off During Braking: When underway the brake switch signals the controller to cut the battery output. |
*Power Connector |
|
Motor
Connector Blue + Yellow - |
Required |
Derailleur Connector |
Required |
Lock Connector |
Required |
Charger
Connector Red + Black - |
Optional |
Brake Signal Connector |
Optional |
Brake Light Connector |
Optional |
Pilot Light Connector |
Optional |
*Make the Battery Connector the last
connection to connect. *The wire coming from the battery should be fuse protected. |